We all know that the main advantage of 3d metal cutter is its fast cutting speed and good cutting quality, which is deeply loved by users. The user will have burrs during actual use. Why does this problem occur? This problem has not occurred in the enclosed fiber laser cutting machine manufacturer. Is it due to the performance of the aluminum laser cutter or the laser cutting process? There is a problem? MYST Laser lists six main causes and solutions for burrs during laser cutting for these problems mentioned by users.
First, explain what burrs are, that is, there are debris and fine microscopic metal particles on the surface of metal cutting. The indicator is that the more burrs, the worse the quality of metal cutting. Here, Henan Bangtai Technology lists the main causes and methods of burrs based on 16 years of experience of cutting laser metal machine manufacturers.
1. The output power of the optical system of the sheet metal for the laser cutting machine is not enough. At this time, you need to check whether the laser generator (laser) is normal. If it emits light normally, observe whether the output value in the laser control panel is normal.
2 The cutting focus of the 2kw laser cutter is offset, which requires the operator to test the focus and adjust it according to the offset of the focus. There are certain requirements for the operating experience of the operators.
3. The upper and lower positions of the laser focus are not correct. Here, the focus test is also required. According to the offset adjustment, MYST Laser has already given an explanation of the laser cutting focus control technology. If you don’t know it, you can go to know.
4. The speed of laser cutting is too slow. Although the speed of laser cutting is relatively fast compared to other processes, the speed of the laser cutter that cuts metal in the processing process should not be too slow, causing burrs to appear. At this time, it is necessary to increase line speed. Ensure the quality of cutting.
5. The running time of the laser machine cut steel online is too long, resulting in burrs caused by the instability of the machine tool. In this case, you only need to restart the equipment.
6. When the fiber optic laser cutting machine is cutting, the purity of the auxiliary gas is not enough for hard burrs. Companies often give up the purchase of some high-cost auxiliary objects due to cost considerations, resulting in the failure to maximize the performance of the equipment. This problem also requires the attention of users and friends. Yes, it is the best choice to save costs on the premise of ensuring the cutting quality and ensuring the cutting quality.
The reasons and solutions for the above several burrs are hoped that users can master them proficiently to maximize fiber laser metal cutting machine performance and maximize economic benefits.